Difference between revisions of "Dynamic Simulations"

Revision as of 11:37, 26 March 2007

Some characters in TWO have Dynamic Constraints as part of their rig. Scarecrow's belt and hat, Woots belt, are two examples.

Here is the current procedure to prepare a scene for rendering so the the dynamics will be correct.

Make as many models inactive as you can (frame 0). Usually this will be all but one. This makes the simulation faster.
Set the rigs dynamic settings to be uniform from frame 0 to the end of the scene.
Turn off Draw Particles/Hair unless hair needs to be simulated too.
Got to frame 0 and right click the choreography and choose Simulate Spring Systems.
Check the animation from ten frames before scene start to ten frames past (usually 90 to 110).
1. If the animation jumps this might cause the simulation to jump. The animation before scene start may need to be adjusted.
2. Resimulate if needed.
If there are two or more characters to simulate make the current one inactive and activate the next one. Repeat the process.
When all characters are simulated, remove any active channels you created from the model's choractions.
Save the choreography.

@@ Line 13: / Line 13: @@
 ## Resimulate if needed.
 # If there are two or more characters to simulate make the current one inactive and activate the next one. Repeat the process.
-# When all characters are simulated, make all models you made inactive active on frame 0.
+# When all characters are simulated, remove any active channels you created from the model's choractions.
+# Save the choreography.